|
Always check your pedals are tight before every ride to a minimum of 310 in-lbs (35 Nm) and ensure your pedal axles are clean (a wire brush works well!) then greased before installation. This will prevent any damage to crank pedal threads.
Similarly, always check crank bolt torque is at least 310 in-lbs (35 Nm) before each and every ride.
Failure to keep your pedals or crank bolts tight is likely to invalidate the warranty on these cranks.
Please note that the minimum required thread contact between crank arm and sprocket/freewheel is 7mm. Failure to adhere to this instruction will damage the cranks threads and this is not covered under warranty.
|